The steel shield steel shield has a good seal, to prevent iron, anti-coolant, anti-Tools accident. A durable, smooth operation, low noise, beautiful appearance. 2 suitable for high-speed motion machine guard rails smooth nor vibration noise. Means not only to protect the life of the sheeting, it is more important to ensure that the machine precision. 4 each section of the shield opened parallel and parallel retracted run freely. Not detached from the guard, percussion, both beautiful and improve the service life of the guard. On the basis of the original sealing tape affixed a layer of stainless steel cover, high temperature iron to prevent burns rub strip the orbit surface strain rail. The steel shield device advantages: 1, guard each piece bursts of the same move, completely different from the general shield piece after piece of pull, so the noise is very low. 2, using the shield of the device can increase service life. 3, steel shield device guard movement speed can rise to 120m/min and withstand higher value of G (2G). Steel shield device shroud with dynamic and parallel (to avoid the shortcomings of the general shear type shields are still hunting). 5, at high speed can be more stable, no vibration generating. Steel, stainless steel the machine guard rails steel telescopic rail shield is a traditional form of protection for the machine. Steel telescopic rails shields in this field has been widely used to prevent the entry of chips and other sharp things plays an effective role in the protection, certain structural measures and appropriate scraping board can effectively reduce the cooling liquid infiltration. I plant steel telescopic rails shields to adapt to the ever-increasing demands of modern machine tools for high-tech, the correct installation position, high operating speed. Technical data Steel telescopic rails shields for high-quality 2-3mm thick steel cold forming can also be made according to the requirements of stainless steel. Special surface finish will make it another appreciation. We can for all types of machine tools to provide the appropriate type of guard rails (horizontal, vertical, inclined and horizontal). We have developed different running speed rail shield structure is also different. Equipped with poly resin or brass slider below the operating speed of 10m/min. The medium speed 30m/min under fitted with rollers. Also, driver board, scraping plates and sucking plate between the need to use a buffer system. The slider buffer system is to reduce the collision noise and friction. The number of sections of steel telescopic rails shields its proportions, weights and operating characteristics are important. Each section should be as long as possible, thus reducing the number of sections and reduce costs. In general the maximum tensile and minimum compression ratio should be between 3:1 and 5:1. The structure, reasonably priced standard structure (1) is suitable for most applications industry, width to 900mm width larger must be hemming and improve lateral stability. This roof type (3) and the hemming (4) can be done. Another tilt type (2) excellent liquid and debris flow away. The number of sections of steel telescopic guards its proportions, weights and operating characteristics are important. Each section should be as long as possible, thus reducing the number of sections and reduce costs. The general maximum tensile smallest compression ratio should be between 3:1 and 5:1 (up to 10:1).